I have tried multiple times with different end numbers using 192.168.0.xxx and save and reboot controller but then the controller home page will not connect and load.
I'm not sure what I am missing?
OK Help needed! I feel like I'm working backwards and about to scrap the whole thing this year!
I have a Falcon F16v3 and a Sandevices E6804 controller. Both set up and worked fine last year. Reecntly I have upgraded to the NBN and received a new modem from Telstra. Now my IP addresses wont...
Could I please get some help with setting up the DMX2-24?
I have it functioning and working in test mode but I have a few queries I need a bit more clarification on.
I have it connected through the DMX port 3 of a falcon F16v3. I assume I don’t add the controller as it’s own set up in the...
Just running from laptop this year so it's working fine. It's my first year, started late and just got the mega tree working. Planning on increasing for next year and running from pi then. Thanks again :)
I've just tested and my sequence plays on the 169.254.x.y address I set and running it with a long ethernet cable from my laptop. Thank you for all your help and advice AJ240 and Kitman :)
It is for the wireless. I ran the control centre again and the ethernet is 169.254.131.2 (see attached). So do you think I can run with the 2 different addresses?
Yes, I can connect to the controllers web page on 169.254.74.73 and also change it to another IP address with 169.254.x.y but can not get it to work with and 192.168.x.y range. On checking the IP address in command prompt it seems it should be a 192.168.1.y range, that's why I'm confused.
Hi,
I'm sorry to need help with such a basic thing but I'm running behind and just needing to get my tree to work.
I have a sandevices e6804 controller.
I have it connected to my computer via Ethernet. I have had to use the override code to get an IP address of 169.254.74.73, I can set it to...
Hi. We have had a static display for the past 6 years and we love all things Christmas lights! I am not great with electronics but I am determined to give the programmable lights a go. I am getting started late I know but I am wanting to get going. I am looking at the Sandevices assembled...